闭式线型喷头静电纺丝及工艺参数影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

东华理工大学博士基金(DHBK2020009);国家自然科学基金资助项目(21664002);教育部产学合作协同育人项目(202101362011)


Impact of Electrospinning and Process Parameters on Closed Linear Spinneret
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为解决产量低、针头堵塞和溶剂挥发的问题,设计了一种闭式线型喷头静电纺丝装置。采用Comsol软件分别模拟了开式、闭式辊筒的电场分布,并研究了各金属丝的电场强度。采用正交实验研究了聚合物溶液浓度、工作电压、纺丝距离和旋转速度4个工艺参数对聚偏二氟乙烯(PVDF)纳米纤维形貌的影响。应用响应面法建立了工艺参数与纳米纤维直径的多元回归模型,评价了4个工艺参数对纳米纤维直径的影响。正交实验获得的纳米纤维平均直径(MFD)为93.85~206.42 nm,相对标准偏差(RSD)为29.28%~45.13%。研究结果表明,PVDF纳米纤维MFD受聚合物溶液浓度和纺丝距离影响显著,受工作电压和旋转速度的影响不显著;PVDF纳米纤维MFD随聚合物溶液浓度、工作电压、旋转速度的增大而增大,随纺丝距离的增大而减小。

    Abstract:

    A electrospinning device with closed linear spinneret was designed to solve the problems of low yield, needle blockage, and solvent evaporation. The electric field distribution of open and closed rollers was simulated by Comsol software, and the electric field strength of each metal wire was studied. The effects of four process parameters, including polymer solution concentration, working voltage, spinning distance, and rotation speed, on the morphology of PVDF nanofibers were studied through orthogonal experiment. A multiple regression model between process parameters and nanofiber diameter was established by response surface methodology, and the impact of four process parameters on nanofiber diameter was evaluated. The average diameter (MFD) of nanofibers obtained from orthogonal experiments is 93.85~206.42 nm, with a relative standard deviation (RSD) of 29.28% ~45.13%. The research results indicate that PVDF nanofiber MFD is significantly affected by polymer solution concentration and spinning distance, but not significantly affected by working voltage and rotation speed; the MFD of PVDF nanofibers increases with the increase of polymer solution concentration, working voltage, and rotation speed, and decreases with the increase of spinning distance.

    参考文献
    相似文献
    引证文献
引用本文

周海迎,范颖鑫,柳和生,邢升,黄俊杰.闭式线型喷头静电纺丝及工艺参数影响[J].高分子材料科学与工程,2024,40(8):68-77. Haiying Zhou, Yingxin Fan, Hesheng Liu, Sheng Xing, Junjie Huang. Impact of Electrospinning and Process Parameters on Closed Linear Spinneret[J]. Polymer Materials Science & Engineering,2024,40(8):68-77.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2024-10-25
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司