乳液成型制备二氧化硅/聚四氟乙烯复合薄膜及其性能优化
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

四川省自然科学基金面上项目(2022NSFSC0357);四川省杰出青年科技人才项目(2022JDJQ0023)


Preparation and Performance Enhancement of Silicon Dioxide/Polytetrafluoroethylene Composite Films by Emulsion Molding
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    聚四氟乙烯(PTFE)由于优异的介电性能已成为高频通讯的重要载体,通常将其与无机填料复配以提高其力学性能。但是,受限于PTFE极低的表面能,无机填料与其界面作用极差,难以在传统车削或压延成膜的强应力作用下实现高填充复合薄膜材料的成型。因此文中尝试以尺寸更小,界面可灵活构筑的PTFE乳液为基体、二氧化硅(SiO2)为无机填料,通过SiO2表面改性对SiO2/PTFE复合膜材料性能强化,研究无机粒子表面改性对复合材料分散、界面及力学性能等的影响。研究发现,当偶联剂质量分数为5%时,SiO2/PTFE复合薄膜(80μm)力学性能最优,拉伸强度由SiO2改性前的4.35MPa增加至5.33MPa、断裂伸长率由38.2%增加至134.0%。为提高PTFE/SiO2界面强度、制备高性能PTFE复合薄膜材料提供了新方法。

    Abstract:

    Polytetrafluoroethylene (PTFE) has become an important carrier for high frequency communication due to its excellent dielectric properties, and is usually compounded with inorganic fillers to improve its mechanical properties. However, due to the extremely low surface energy of PTFE itself, the interface between inorganic fillers and PTFE is extremely poor, and it is difficult to achieve the molding of high-filled composite film materials through traditional turning or calendering. Therefore, this study attempted to use PTFE emulsion with smaller size and flexible interface as matrix, and silicon dioxide (SiO2 ) as inorganic fillers to study the effect of surface modification of inorganic particles on the dispersion, interface and mechanical properties of the composites. It is found that when the mass fraction of coupling agent is 5%, the mechanical properties of SiO2/PTFE composite film (80 μm) are the best, the tensile strength increases from 4.35 MPa to 5.33 MPa, and the elongation at break increases from 38.2% to 134.0% . This study provided a new method for improving the interfacial strength of PTFE/SiO2 and preparing PTFE composite film materials.

    参考文献
    相似文献
    引证文献
引用本文

高炜,周茜,沈佳斌,陈蓉,郭少云.乳液成型制备二氧化硅/聚四氟乙烯复合薄膜及其性能优化[J].高分子材料科学与工程,2024,40(8):107-114. Wei Gao, Qian Zhou, Jiabin Shen, Rong Chen, Shaoyun Guo. Preparation and Performance Enhancement of Silicon Dioxide/Polytetrafluoroethylene Composite Films by Emulsion Molding[J]. Polymer Materials Science & Engineering,2024,40(8):107-114.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2024-10-25
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司