Abstract:Polymer/rGO80% and polymer/rGO50% as supporting materials of electrocatalyst were prepared by modification of reduced graphene oxide (rGO) via in- situ polymerization of 3- pyridinyl- 2,5- dithienylthiophene with D-A structure as monomer through adjusting the ratio of monomer and rGO. Then, rGO/Pd, polymer/rGO80%/Pd and polymer/rGO50%/Pd composites were prepared by loading platinum nano- particle on surface of rGO, polymer/rGO80% and polymer/rGO50% . The electrocatalys were characterized by Fourier translation infrared spectroscopy (FT- IR), scanning electron microscope (SEM), transmission electron microscope (TEM) and inductively coupled plasma atomic emission spectrometry (ICP-AES). Methanol electrooxidation performance of electrocatalys was studied by these electrochemical test methods such as cyclic voltammetry measurement and amperometric I- t curve measurement. The results show that electrochemically active surface area of rGO/Pd, polymer/rGO80%/Pd and polymer/rGO50%/Pd in 0.5 mol/L KOH solution is 195.2 cm2/mg, 280.1 cm2/mg and 428.1 cm2/mg, respectively. The methanol electrooxidation peak current densities of rGO/Pd, polymer/rGO80%/Pd and polymer/rGO50%/Pd in 0.5 mol/L KOH + 1 mol/L CH3OH solution are 235.31 mA/mg, 783.83 mA/mg and 1146.36 mA/mg, respectively. Comparing with rGO/Pd, the electrocatalytic activities of polymer/rGO80%/Pd and polymer/rGO50%/Pd are 3.3 times and 4.9 times that of rGO/Pd, respectively. These results indicate that the optimum amount of polymer in composite is 50%. The rGO modified with pendant pyridinyl grafted polyterthiophene can enhance the electrocatalytic performance and electrocatalytic stability of rGO/Pd electrocatalyst.