Abstract:Fatty acids are one of the important non-rubber component of natural rubber (NR). In this paper, samples were prepared by two strains (Reyan 73397, IAN873), three solidification methods (formic acid coagulation, sulfuric acid coagulation, natural coagulation) and two standard glue processes (full latex standard glue process (WF), gel standard glue process (TSR)) to study the influence of solidification method on fatty acid content in natural rubber, and to find out the specific effect of fatty acid content variability on the mechanical properties of NR. The results show that the coagulation method would have a significant effect on the non-gel component, and the fatty acid content of the sample is the best by the sulfuric acid coagulation method. In terms of mechanical properties, the appropriate consumption of non-glue components is conducive to vulcanization reaction, which corresponds to the natural solidification method, vulcanized rubber has the highest mechanical properties, while the sulfuric acid solidification has the lowest mechanical properties. Under the WF process, the mechanical properties of natural solidification vulcanized rubber decrease with the extension of curing time.Under the TSR process, with the extension of curing time, the mechanical properties of naturally solidified vulcanized rubber decrease. Under the same process, the weight-average molecular weight and gel content of IAN 873 strain are higher than those of Reyan 73397, while the gel content of formic acid and natural solidification samples increases to varying degrees after clot curing, but the gel content of sulfuric acid solidification hardly changes, and the gel content of the TSR process sample is the lowest, indicating that sulfuric acid coagulation hinders the structuring of rubber molecular chains during the curing process.