静电纺石墨烯/聚偏氟乙烯纤维膜的制备及其空气过滤性能
DOI:
作者:
作者单位:

1.柔性制造装备集成福建省高校重点实验室(厦门工学院),福建 厦门 361021;2.厦门工学院机械电气与信息工程学院,福建 厦门 361021;3.厦门大学萨本栋微米纳米科学技术研究院,福建 厦门 361102

作者简介:

通讯作者:

中图分类号:

基金项目:

柔性制造装备集成福建省高校重点实验室(厦门工学院)(pklfmeiz20240010);国家自然科学基金资助项目(52275575);厦门市自然科学基金资助项目(3502Z20227329);厦门工学院科研项目(KYTD202102)


Preparation and Air Filtration Performance of Electrospun Gr/PVDF Nanofiber Membrane
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为了获得空气过滤性能较好的纤维材料,以聚偏氟乙烯作为聚合物基体,添加不同石墨烯(Gr)浓度的导电纳米填料石墨烯,通过共混法配制了不同导电率的电纺溶液,并采用静电纺丝工艺制备石墨烯(Gr)/聚偏氟乙烯(PVDF)复合导电纳米纤维空气过滤膜,通过多种表征方法测试不同Gr浓度(0wt.%、0.1wt.%、0.2wt.%、0.3wt.%、0.4wt.%、0.5wt.%)的Gr/PVDF复合纳米纤维膜的性能差异,完成了其形貌分析、纺丝溶液导电率、纤维膜的过滤效率、过滤压降和过滤性能的测试,实验结果表明:静电纺丝工艺制备的Gr/PVDF复合纳米纤维膜,其过滤效率随着纺丝溶液导电率的增大而增大后趋于平稳,同时过滤效率和过滤性能的品质因数(QF)值都随着石墨烯添加浓度的增大先增大后趋于稳定,当石墨烯添加浓度为0.3wt.%时,纺丝溶液电导率达到最大值12.04μS/cm(折算至25℃),对应Gr/PVDF复合纳米纤维膜的过滤效率最大为98.6%,过滤压降最小为16.33Pa,QF最优值为0.2608。上述研究为空气过滤提出了新型纳米纤维材料,为运用复合纤维膜实现高效的空气过滤提供了理论依据。

    Abstract:

    In order to obtain fiber materials with good air filtration performance, polyvinylidene fluoride was used as the polymer matrix, and conductive nanofiller graphene with different graphite (Gr) concentrations was added. Electrospinning solution was prepared by blending method, and graphite (Gr)/polyvinylidene fluoride (PVDF) composite conductive nanofiber air filtration membrane was prepared by electrospinning process. The performance differences of Gr/PVDF composite nanofiber membranes with different Gr concentrations (0, 0.1 wt.%, 0.2 wt.%, 0.3 wt.%, 0.4 wt.%, 0.5 wt.%) were tested by various characterization methods. The morphology analysis, spinning solution conductivity, filtration efficiency, filtration pressure drop and filtration performance of the fiber membrane were completed. The experimental results showed that the Gr/PVDF composite nanofiber membrane prepared by electrospinning process had different properties. The sentence is: The filtration efficiency of the composite nanofiber membrane increases with the increase of the conductivity of the spinning solution and then tends to stabilize. At the same time, both the filtration efficiency and the filtration performance QF value increase first and then tend to stabilize with the increase of graphene addition concentration. When the graphene addition concentration is 0.3 wt.%, the spinning solution conductivity reaches the maximum value of 12.04 μ S/cm (converted to 25 ℃), corresponding to a maximum filtration efficiency of 98.6%, a minimum filtration pressure drop of 16.33 Pa, and an optimal filtration performance of 0.2608 for the Gr/PVDF composite nanofiber membrane. The above research proposes a new type of nanofiber material for good air filtration, providing a theoretical basis for the use of composite fiber membranes to achieve efficient air filtration.

    参考文献
    相似文献
    引证文献
引用本文
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2025-09-10
  • 录用日期:2026-02-13
  • 网络出版日期:2026-09-09
  • 在线发布日期:
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司