溶解法制备聚酰亚胺溶液的流变行为与均匀稳定性
DOI:
作者:
作者单位:

先进纤维材料全国重点实验室 东华大学材料科学与工程学院,上海 201620

作者简介:

通讯作者:

中图分类号:

基金项目:


Rheological Behavior and Uniform Stability of Polyimide Solution Prepared by Dissolution Method
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用溶解法制备高浓度聚酰亚胺(PI)溶液是提升PI纤维生产效率和产品性能的有效路径,但是PI浓度升高易引发溶液均匀稳定性下降。针对该矛盾,本文以二苯酮四酸二酐-甲苯二异氰酸酯/二苯基甲烷二异氰酸酯三元共聚PI为原料,选择N-甲基吡咯烷酮(NMP)与N,N-二甲基乙酰胺(DMAc)两种常用PI溶剂,制备了质量分数为15 wt%~32 wt%的PI溶液,通过流变性能研究溶液浓度与其均匀稳定性的内在关联。结果表明,NMP因其环状刚性分子结构及优异的溶剂化能力,可有效抑制PI分子链蜷缩与溶液相分离,适用于制备高浓度PI溶液。PI/NMP溶液的临界缠结浓度约为27 wt%,当溶液浓度达到27 wt%,稳态剪切扫描下剪切变稀的起始剪切速率明显降低,零切粘度与松弛时间增加,表现出显著的剪切变稀行为与粘弹性响应;当溶液浓度提升至32 wt%时,稳态表观粘度与动态复数粘度在低频区重合度降低,表现出非均相特征,且对温度变化更敏感。因此,从PI溶液均匀稳定性考虑,建议选择NMP作为溶剂,溶液浓度控制在27 wt%~30 wt%。

    Abstract:

    Preparing high-concentration polyimide (PI) solutions via the dissolution method is an effective approach to enhance both production efficiency and product performance in PI fiber manufacturing. However, increasing PI concentration often leads to reduced solution homogeneity and stability. To address this challenge, this study used a ternary copolymer of benzophenone tetracarboxylic dianhydride with toluene diisocyanate and diphenylmethane-4,4'-diisocyanate as the raw material, and selected two commonly used PI solvents N-methylpyrrolidone (NMP) and N,N-dimethylacetamide (DMAc) to prepare PI solutions with mass fractions ranging from 15 wt% to 32 wt%. The intrinsic relationship between solution concentration and its homogeneity and stability was investigated through rheological analysis. Results show that NMP, due to its rigid cyclic molecular structure and excellent solvating ability, effectively suppresses PI chain folding and phase separation, making it suitable for preparing high-concentration PI solutions. The critical entanglement concentration of PI/NMP solutions is approximately 27 wt%; at this concentration, the onset shear rate of shear thinning during steady-state shear scanning significantly decreases, while zero-shear viscosity and relaxation time increase, indicating pronounced shear-thinning behavior and viscoelastic response. When the concentration increases to 32 wt%, the overlap between steady-state apparent viscosity and dynamic complex viscosity in the low-frequency region diminishes, revealing heterogeneous characteristics and greater sensitivity to temperature changes. Therefore, considering the homogeneity and stability of PI solutions, NMP is recommended as the preferred solvent, with solution concentration ideally maintained between 27 wt% and 30 wt%.

    参考文献
    相似文献
    引证文献
引用本文
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2025-09-28
  • 录用日期:2026-04-01
  • 网络出版日期:2026-09-22
  • 在线发布日期:
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司