不同催化体系制备聚壬二酸戊二醇酯及其性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Properties of Poly(Pentylene Glycol Azelate) Prepared with Different Catalytic System
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    与传统偶数-偶数聚酯不同,奇数-奇数聚酯一般具有较低的结晶性能、良好的热性能和降解性能。然而,目前有关奇数-奇数聚酯的聚合反应条件研究相对较少。文中分别采用钛酸正丁酯、钛酸异丙酯、异辛酸锡、无水氯化亚锡和对苯甲磺酸为催化剂,通过溶液缩聚法合成了聚壬二酸戊二醇酯(PPeAz)。通过比较不同催化体系对PPeAz 特性黏度、化学结构、晶体结构、热性能和酶解性能的影响,得到了高效的催化剂及综合性能最佳的PPeAz,为奇数-奇数脂肪族聚酯研究奠定了基础。不同催化剂制备的PPeAz 相对黏度大小顺序依次为:钛酸异丙酯>钛酸正丁酯>对苯甲磺酸>异辛酸锡>无水氯化亚锡>无催化剂。其中由钛酸异丙酯催化得到的白色PPeAz 缩聚时间最短,仅6 h,产率最高,特性黏度最大,为0.857 dL/g,结晶度最低,熔融温度最高,热稳定性最好,酶解速率最快,10 h 即可完全降解。

    Abstract:

    Unlike conventional even- even polyesters, odd- odd polyesters generally have lower crystalline properties, good thermal properties and degradation properties. However, there are relatively few studies on the polymerisation reaction conditions of odd-odd polyesters. In the study, poly(pentylene glycol azelate) (PPeAz), an odd- odd aliphatic polyester, was synthesized by solution polycondensation using n- butyl titanate, isopropyl titanate, tin isooctanoate, anhydrous stannous chloride, and p- benzene methanesulfonic acid as catalysts, respectively. By comparing the effects of different catalytic system on the characteristic viscosity, chemical structure, crystal structure, thermal properties and enzymatic properties of PPeAz, efficient catalysts and PPeAz with the best overall performance were obtained, laying the foundation for the study of odd- odd aliphatic polyesters. The relative viscosities of PPeAz prepared with different catalyst were in the following order: titanium tetraisopropanolate > tetrabutyl titanate > p- toluenesulfonic acid > stannous octoate > tin(II) chloride > catalystfree. The white PPeAz catalyzed with isopropyl titanate has the shortest polycondensation time of only 6 h, the highest yield, the largest characteristic viscosity of 0.857 dL/g, the lowest crystallinity, the highest melting temperature, the best thermal stability, the fastest enzyme degradation rate, and the degradation could be completed in 10 h.

    参考文献
    相似文献
    引证文献
引用本文

程薪如,郝文博,黄辰昊,苏婷婷.不同催化体系制备聚壬二酸戊二醇酯及其性能[J].高分子材料科学与工程,2025,41(5):10-16. Xinru Cheng, Wenbo Hao, Chenhao Huang, Tingting Su. Properties of Poly(Pentylene Glycol Azelate) Prepared with Different Catalytic System[J]. Polymer Materials Science & Engineering,2025,41(5):10-16.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2025-08-31
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司