聚偏氟乙烯共混催化膜的制备及其染料吸附催化性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

水处理功能材料湖南省重点实验室开放基金(KFJJ2301);山东省科技型中小企业创新能力提升工程项目(2023TSGC0924)


Preparation of Polyvinylidene Fluoride Blended Catalytic Membrane and Its Dye Adsorption and Catalytic Performance
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    受扩散控制的影响,异相Fenton过程催化效率往往较低。近年来,将Fenton技术和膜技术结合以强化催化过程成为处理废水的研究热点。文中首先以4A沸石为载体,制备了具有核壳结构的铜催化剂(4A@Cu),随后和化学稳定性好、力学性能优良的聚偏氟乙烯(PVDF)通过共混的方式制备了4A@Cu/PVDF催化膜,并将其用于刚果红(CR)、罗丹明B(RhB)的催化降解。结果显示,和RhB相比,4A@Cu对阴离子染料CR具有优异的吸附性能,且吸附作用大大促进了催化膜对CR的降解。此外,膜孔提供的对流能够强化传质,降低催化过程中染料扩散的传质阻力,促进膜内4A@Cu Fenton催化剂对CR染料的降解,拓宽Fenton反应pH。在错流循环模式下,当膜内4A@Cu/CR质量比为1/1、CR初始浓度为200 mg/L时,催化膜对CR的最大吸附量为2462.8 mg/g4A-Fe@Cu。当膜内4A@Cu/CR质量比为5/1,H2O2浓度为2 mmol/L,pH=6的条件下,催化膜在5 h后对CR的去除率为99.8%,远优于静态催化过程。Fenton催化剂和膜技术相结合实现了CR的高效降解,为染料污染物的有效去除提供了一种潜在可行的方法。

    Abstract:

    Due to the influence of diffusion control, the catalytic efficiency of heterogeneous Fenton process is often low. In recent years, the combination of Fenton technology and membrane technology to strengthen the catalytic process has become a research hotspot for effective wastewater treatment. In this study, a core- shell copper catalyst (4A@Cu) was prepared using 4A zeolite as support through in- situ growth method, and then the 4A@Cu/PVDF catalytic membrane was prepared by blending polyvinylidene fluoride (PVDF) with good chemical stability and excellent mechanical properties, and was used for the catalytic degradation of Congo red (CR) and Rhodamine B (RhB). The results show that, compared with RhB, the excellent adsorption performance of 4A@Cu promotes the degradation of CR. In addition, the convection provided by the membrane pores can strengthen mass transfer, reduce the mass transfer resistance of pollutant diffusion during catalytic process, promote the degradation of CR by 4A@Cu Fenton catalyst in membrane, and broaden the pH of Fenton reaction. Under cross- flow circulation mode, when the mass ratio of 4A@Cu/CR in the membrane is 1/1 and the initial concentration of CR is 200 mg/L, the maximum adsorption capacity of CR by the catalytic membrane is 2462.8 mg/g4A-Fe@Cu. When the mass ratio of 4A@Cu/CR in the membrane is 5/1, the concentration of H2O2 is 2 mmol/L, and pH is 6, the removal rate of CR by the catalytic membrane is 99.8% after 5 h, which is much better than that of the static catalytic process. The combination of Fenton catalyst and membrane technology realizes the efficient degradation of CR, which provides a potential feasible method for the effective removal of dye pollutants.

    参考文献
    相似文献
    引证文献
引用本文

黄莉洁,陈豪杰,吴剑宇,张婉菊,宁 鑫,马 冯,徐 诚,黄莉兰.聚偏氟乙烯共混催化膜的制备及其染料吸附催化性能[J].高分子材料科学与工程,2025,41(5):121-130. Lijie Huang, Haojie Chen, Jianyu Wu, Wanju Zhang, Xin Ning, Feng Ma, Cheng Xu, Lilan Huang. Preparation of Polyvinylidene Fluoride Blended Catalytic Membrane and Its Dye Adsorption and Catalytic Performance[J]. Polymer Materials Science & Engineering,2025,41(5):121-130.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2025-08-31
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司