Abstract:The mechanical properties, especially the low-temperature toughness, of polycarbonate/acrylonitrile- butadiene- styrene copolymer (PC/ABS) flame- retardant composites are relatively low, which limit their application range. In this study, ABS high- rubber powder was used to assist ball milling, leveraging its high toughness to absorb the impact force during milling process, thereby promoting the in-situ exfoliation of graphite (GT) to prepare a toughening masterbatch containing ABS high- rubber powder and graphite nanosheets (GNP). This masterbatch was further blended with PC, ABS and flame retardants via twin-screw extrusion to fabricate PC/ABS flame-retardant composites. The results show that GNP prepared by ball milling GT for 10 h with ABS high-rubber powder assistance has a lateral size of 3 μm and a thickness of 10~15 nm. Compared with the system without GNP, the tensile strength of the composite material containing 0.1% GNP increases from 55.11 MPa to 57.13 MPa, an increase of 3.67% ; the impact strength at 23 ℃ increases from 42.45 kJ/m2 to 50.44 kJ/m2, an increase of 18.82%; especially, the low-temperature impact strength at -30℃ increases from 13.73 kJ/m2 to 20.96 kJ/m2, an increase of 52.66% . GNP in the composite not only transfers stress, inducing microcracks, layer breakage, and interfacial debonding, but also promotes plastic deformation, disperses and consumes energy, reduces stress concentration, thereby enhancing the mechanical properties, especially the low- temperature toughness. This study provides a simple and efficient strategy for the high-performance development of PC/ABS flame-retardant composites.