Abstract:In order to alleviate the environmental pressure caused by waste cotton stalks and improve the comprehensive utilization rate of cotton stalk by- products, this study adopted the low eutectic solvent method to separate lignin in cotton stalks, investigated the effects of factors on the separation effect, and analyzed the properties of cotton stalk lignin and their influence on the mechanical properties and antioxidant properties of polybutylene adipate/terephthalate (PBAT). The results show that the extraction rate of lignin from cotton stalks could reach 89.01%under the conditions of reaction temperature of 120 ℃,reaction time of 12 h, and the ratio of low eutectic solvent (DES) to n-butanol of 2:1.The characterization of lignin by FT-IR, SEM, and TGA shows that the extracted lignin has high purity, structural integrity, and high thermal stability. In order to solve the problems of high cost and poor tensile strength of PBAT, PBAT- g- HI (HEMA- IPDI) was prepared by melt blending and extrusion in a non- catalyzed system, and the obtained graft was purified, melted and extruded with PBAT and cotton stalk lignin, and followed by film blowing to finally obtain the PBAT/cotton stalk lignin composite film. The experimental results show that when the filling level of PBAT- g- HI is 8%and the lignin content of cotton stalks is 10%, the tensile strength and elongation at break are increased by 56.04%and 9.20%, respectively. The crystallinity of the PBAT/cotton stalks lignin composite film is increased from 26.59%to 29.32%, which indicates that the lignin extracted by the low eutectic solvent method could improve the mechanical properties of PBAT.