乙酰化淀粉与聚羟基丁酸酯协同作用对聚乳酸力学性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(21766004);广西高校中青年教师科研基础能力提升项目(2023KY0175);广西民族大学科研基金资助项目(引进人才科研启动项目, 2024KJQD06);广西民族大学研究生教育创新计划项目(gxmzu-chxs2024227)


Effect of Acetylated Starch/Polyhydroxybutyrate Synergistic Action on Mechanical Properties of Polylactic Acid
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    聚乳酸(PLA)是一种具有完全降解能力的热塑性材料。然而,其较高的成本和较差的力学性能限制了其广泛应用。为了克服这些不足,文中采用浇铸法制备了聚乳酸/乙酰化淀粉/聚羟基丁酸酯(PLA/ACS/PHB)三元共混复合薄膜,以使 PLA 能更好地应用到包装行业。为探讨 ACS 和 PHB 对 PLA 力学性能的协同增强作用,首先制备了不同取代度(DS)的 ACS 与 PLA 的二元复合薄膜,对其力学性能进行了分析。在此基础上,为进一步增强和优化薄膜的力学性能,向二元混合材料中分别加入 5%,10%,15%和 20%的 PHB,制备了 PLA/ACS/PHB 三元复合薄膜,对其进行了更深入的力学性能评估。结果表明,PLA 与 ACS 以 7:3 的质量比共混时,复合薄膜的力学性能发生了显著变化。值得注意的是,在 PLA 与 ACS(1:1)薄膜中加入 10%的 PHB 后,较未添加 PHB 的 PLA/ACS(1:1)薄膜,断裂伸长率(EB)提高了约115%,表明 PHB 的加入在增强复合薄膜延展性方面具有显著效果。

    Abstract:

    Polylactic acid (PLA) is a thermoplastic material with complete degradation ability. However, its high cost and limited mechanical properties limit its wide application. In order to overcome these shortcomings, polylactic acid/acetylated starch/polyhydroxybutyrate (PLA/ACS/PHB) ternary blend composite films were prepared by casting method, so that PLA can be better applied to material packaging industry. In order to investigate the synergistic enhancement of ACS and PHB on the mechanical properties of PLA, binary composite films of ACS and PLA with different degrees of substitution (DS) were prepared and their mechanical properties were analyzed. On this basis, in order to further enhance and optimize the mechanical properties of the films, PLA/ACS/PHB ternary composite films were prepared by adding 5%, 10%, 15%and 20%PHB to the binary mixed materials, respectively, and the mechanical properties of the films were further evaluated. The experimental results show that the mechanical properties of the composite films change significantly when PLA and ACS are blended at amass ratio of 7:3.It is worth noting that the elongation at break (EB) of PLA/ACS (1:1)films is increased by about 115%when 10%PHB was added to the film, compared with the PLA/ACS (1:1)film without PHB. The results show that the addition of PHB has a remarkable effect in enhancing the ductility of composite films.

    参考文献
    相似文献
    引证文献
引用本文

李 俊,李智聪,王静文,姚先超,林日辉.乙酰化淀粉与聚羟基丁酸酯协同作用对聚乳酸力学性能的影响[J].高分子材料科学与工程,2025,41(8):117-126. Jun Li, Zhicong Li, Jingwen Wang, Xianchao Yao, Rihui Lin. Effect of Acetylated Starch/Polyhydroxybutyrate Synergistic Action on Mechanical Properties of Polylactic Acid[J]. Polymer Materials Science & Engineering,2025,41(8):117-126.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2025-12-05
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司