基于2,2,4,4-四甲基-1,3-环丁二醇的共聚酯的结构与性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

浙江省现代纺织技术创新中心定向项目 (CXZX2023019HD)


Structure and Properties of Copolyesters Based on 2,2,4,4-Tetramethyl-1,3-Cyclobutanediol
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    文中采用直接酯化-熔融缩聚法,在聚对苯二甲酸乙二醇酯( PET) 中引入2,2,4,4-四甲基-1,3-环丁二醇(CBDO)单体,制备了聚对苯二甲酸乙二醇酯-对苯二甲酸2,2,4,4-四甲基-1,3-环丁二醇酯( PECT)。利用红外光谱、核磁共振氢谱、X 射线衍射、动态力学热分析与紫外可见近红外分光光度计等测试,研究了CBDO 添加比例对共聚酯化学结构、热性能、结晶性能、力学性能及透光率的影响。结果表明,随着CBDO 投料比增加,共聚酯特性黏度与相对分子质量逐渐下降;CBDO 含量上升,共聚酯的玻璃化转变温度(Tg)逐步升高,投料比为30% 时,样品的Tg 升至92 ℃ ;不同CBDO 含量的共聚酯,最大失重速率温度均高于429 ℃ ,保持在较高水平;当CBDO 投料比大于10% ,样品由结晶性聚合物转变为非结晶性聚合物,其薄膜结晶前后可见光透过率均保持在90% 左右;随着CBDO 单元引入,聚合物拉伸强度逐步提升,当投料比为15% 时,样品拉伸强度为65.9 MPa。通过控制CBDO 投料比,可制备Tg 较高,透明度优异且力学性能良好的共聚酯,有利于扩大其应用领域。

    Abstract:

    2,2,4,4-Tetramethyl-1,3-cyclobutanediol (CBDO) monomer was introduced into polyethylene terephthalate (PET) by direct esterification-melt polycondensation to prepare polyethylene terephthalateterephthalic acid 2,2,4,4-tetramethyl-1,3-cyclobutanediol (PECT). FT-IR, 1H-NMR, XRD, DMA and UV-visible near-infrared spectrophotometer were used to study the effects of different CBDO addition ratios on the chemical structure, thermal properties, crystallization properties, mechanical properties and light transmittance of copolyesters. The results show that with the increase of CBDO feed ratio the intrinsic viscosity and molecular weight of copolyester decrease gradually. With the increase of CBDO content, the glass transition temperature (Tg) of the copolyester gradually increases. When the feeding ratio is 30%, Tg of the sample increases to 92 ℃ . The temperature at the maximum mass loss rate of copolyesters with different CBDO contents is higher than 429 ℃, which still maintains at a high level. When the CBDO feed ratio is greater than 10%, the sample changes from crystalline polymer to non-crystalline polymer, and the visible light transmittance of the film before and after crystallization maintains at about 90% . With the introduction of CBDO units, the tensile strength of the polymer gradually increases. When the feed ratio is 15%, the tensile strength of the sample is 65.9 MPa. By controlling the feed ratio of CBDO, copolyesters with high Tg, excellent transparency and good mechanical properties can be prepared to expand their application fields.

    参考文献
    相似文献
    引证文献
引用本文

肖汪洋, 廖梦蝶, 李鸿鑫, 赵 漫, 张须臻, 王秀华.基于2,2,4,4-四甲基-1,3-环丁二醇的共聚酯的结构与性能[J].高分子材料科学与工程,2025,41(12):1-11. Wangyang Xiao, Mengdie Liao, Hongxin Li, Man Zhao, Xuzhen Zhang, Xiuhua Wang. Structure and Properties of Copolyesters Based on 2,2,4,4-Tetramethyl-1,3-Cyclobutanediol[J]. Polymer Materials Science & Engineering,2025,41(12):1-11.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2026-03-21
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司